Products

Tecsi Industrial Nozzles » Air Atomising Nozzles

Configurations

3.4.6.1 Configurations The spray set-up is a matched pair of air cap and fluid cap used to determine the capacity and spray pattern. Spray set-ups are interchangeable, and can be assembled with a...

Air Atomising Nozzles - Accessories

Air atomising nozzles can be supplied with manual shut off or clean-out needle assemblies or tip extensions, or as automatic spray guns (Type PA) to control the fluid flow. Standard model is fitted...

Automatic Gun Type PA

The PA automatic spray gun range may be fitted with any of the air atomising spray set-ups listed. They allow on-off control of liquid spray by operation of an integral air operated piston, at a rate...

Automatic Guns Alternative Models

Automatic spray guns may be supplied in several configurations. Type PA1 is the standard model. Type PA3 is a compact model with all air and liquid ports 1/8"BSPT female. Gun type PA1-RA is...

Full Cone Under Pressure

Type P-11, P-12, P-13 and P-14 air caps provide a finely atomised full cone spray pattern when liquid is pumped to the nozzle assembly. Note: excessive atomising air pressure may cause backflow in...

Flat Jet Siphon

Type S-21, S-22, S-23, and S-24 air caps will draw liquid into the nozzle assembly by venturi (siphon) action of the atomising air, to provide a finely atomised flat cone spray pattern. Liquid flow...

Full Cone Wide

Type P-21, P-22, P-23, P-24 and P-25 air caps provide a wider finely atomised full cone spray pattern when liquid is pumped to the nozzle assembly. Note: excessive atomising air pressure may cause...

Flat Jet Under Pressure

Type P-31, P-31A, P-32, P-33 and P-34 air caps provide a wide finely atomised flat spray pattern when liquid is pumped to the nozzle assembly. The pattern is maintained for up to 400mm from the...

External Mix

Type P-41, P-42 and P-43 air caps provide a finely atomised flat spray pattern when liquid is pumped  to the nozzle assembly. This nozzle is recommended to spray viscous liquids.

Full Cone Siphon

Type S-11, S-12, S-14, and S-15 air caps will draw liquid into the nozzle assembly by venturi (siphon) action to provide a finely atomised full cone spray. Liquid flow can be controlled by varying...